NOS jets have long and skinny *shanks* <that is a term made up by me for lack of a better term.

NX jets have short and fat shanks.

It seems there are multiple jets out there, but they are either short and fat, or long and skinny.

NOS nozzles have the jet hole that is skinny and deep.

NX nozzles have the jet hole that is fat and shallow.

What I'm thinking is to take the NX nozzle and drill it a little deeper. That way I can use either size jets in just about every brand out there.

The flared tops on the jets are the same. So I don't see a problem doing this unless when running a short jet in a deep hole could cause some sort of problem with the flow?

Ideas/Comments welcome!