I just replaced the input shaft seal but am still getting an oil drip from the bellhousing. What is going on!! I just don't get it.
I just replaced the input shaft seal but am still getting an oil drip from the bellhousing. What is going on!! I just don't get it.
rear main seal?
that's new too
pan gasket?
How was the surface on the input shaft? Did you RTV the input shaft seal housing?
Justin
84 Plymouth Voyager LE 2.5 Intercooled Turbo 5-spd - Only 84 Turbo Van!
89 Dodge Caravan ES 2.4 SRT-4 Intercooled Turbo (46 trim, OS Valves, CP Pistons, Eagle Rods, NPR IC) Built 31th trans
91 Dodge Shadow Convertible 2.5 Intercooled Turbo A555 5-spd
01 Pontiac Grand Prix GTP - 3.8 supercharged! Only 5K miles....
01 Subaru Forester - Daily Driver
07 Yamaha FJR 1300 140+ HP on 2 wheels
85 Honda Nighthawk 450
94 Bobcat 763 Skidloader 2.2 Kubota Diesel
SV-SDAC Member
Seal in backwards ? Flat side toward clutch ?