hello all....
hi gang....
decided to go straight to the 2.5 turbo intercooled setup when i restore my 86 aries wagon and so i have a perfectly good 2.5tbi from my old 91 dynasty not getting used. been thinking of fixing up my previous daily driver, an 87 ram 50 short bed, standard cab, 5spd, 2wd, manual everything. it was my grandfathers truck and i'm curious about the swap. obviously i will have to run fuel injection as the 91 2.5 block doesn't have the provision for a mechanical pump. wiring and fuel delivery is not an issues. my only problems are what can i do to bolt the 2.5 to the mitsubishi trans, starter location, engine mounts, etc. seems a lot of dodges came with mitsu 4 bangers in them. be interesting to see a chrysler powerplant in a mitsubishi. it would save on buying a mitsu 2.4 to replace that tired 2.0. also, it will be fun to drive a car with a 2.5tbi with a stick instead of an auto! be happy to hear replies....just trying to spend what little budget i have on hammering out the rust and saving the truck and use up some of the parts i have sitting around.