Koni Struts

[Mario]

Alright ladies now show me the Konis!

[tryingbe]

Here are how my Koni looks. Sorry, you can't pay me enough to sell them.

[Mario]

? I don't really understand the point of that post. I think you should re-word that to say, "You probably don't want to pay me how much I'd let these go for."

[glhs727]

I have a NEW set (fronts and rears) that I'm thinking of putting on ebay.

[Turbo SOB]

I have some, I e-mailed you. Hope to hear from you.

Later,
Jeff

[Mario]

Thanks. Replied.

[turbovanman²]

? I don't really understand the point of that post. I think you should re-word that to say, "You probably don't want to pay me how much I'd let these go for."

He's being an ahole, showing you HIS new ones,

[Shadowv4l]

FROM: KYB AGX MODIFICATION THREAD

Just got the Koni adjustable strut tubes today, made some measurements and feel pretty good about it. I'm going to take a STOCK strut tower assy. and put the Subaru yellow Koni Tubes into the Stock strut assy. This way i know the length of the tube and shaft is correct, only mod i would have to do is the lathe of the shaft 3/4 of an inch from the threaded area.
Apparently the only way to get the koni is by getting the tube inserts, if i was going to do the work to install them into subaru strut assy. why not try to put them into our OE strut assy. this
way i wouldn't have to change the camber adjustment holes that attach to the knuckle.

[turbo_III]

FROM: KYB AGX MODIFICATION THREAD

Just got the Koni adjustable strut tubes today, made some measurements and feel pretty good about it. I'm going to take a STOCK strut tower assy. and put the Subaru yellow Koni Tubes into the Stock strut assy. This way i know the length of the tube and shaft is correct, only mod i would have to do is the lathe of the shaft 3/4 of an inch from the threaded area.
Apparently the only way to get the koni is by getting the tube inserts, if i was going to do the work to install them into subaru strut assy. why not try to put them into our OE strut assy. this
way i wouldn't have to change the camber adjustment holes that attach to the knuckle.

I'm liking your thinking...can't wait to hear and see results!!

[Mopar318]

What part numbers are you looking for? I found a few website a while back that verified they could get them. Just want to make sure I have the correct part #'s and Ill PM you the links.

[cqlink]

I just ditched the KYB struts on my '86S and had the Konis rebuilt. Big improvement. Handling in corners is amazing. Yes, I was out $450 (including shipping) because one of the pistons ($60 part) was shot but if you can come up with the $$$ it's worth it.

[turbovanman²]

What part numbers are you looking for? I found a few website a while back that verified they could get them. Just want to make sure I have the correct part #'s and Ill PM you the links.

They all say that and they don't have any,