Switch from 2bar to 3bar question ASAP

[Rattlesnake]

Hi guys, I just installed my new cal on my car with the 3bar map sensor. I had a code for map signal not changing. My question is: When you switch from 2 to 3bar sensor, do you just connect the plug or you have to arrange the wiring on the plug before you connect it to the sensor?
Need asap, going to track tomorrow.

Thanks

[altered7151]

You have to notch one of the terminals on the plug side so that it fits into the map sensor properly. Maybe you have it plugged in the wrong way?

[Rattlesnake]

You have to notch one of the terminals on the plug side so that it fits into the map sensor properly. Maybe you have it plugged in the wrong way?

Already did that 2 years ago when I had a Super60 cal. Do you have to rotate the connector?

[GLHSKEN]

No just notch and go.

[Rattlesnake]

No just notch and go.

Thanks Ken