a520 swap into L-body parts wanted

[LaserGurl]

Hey!

I pulled my a520 out of storage to get ready to swap it into my shelby charger and it seems a few things are missing... the clutch release lever and the bar it attaches too ( the part which mounts the throwout bearing) and the main mount.

Will the corresponding parts from the a525 fit the a520? and if not where could I find these things?

Any help would be appreciated!

Thanks

Tifany

[BadAssPerformance]

The A525 parts might fit... never compared them.

Do you have the cables and shifter and rear trans mount for the A520 too?

[LaserGurl]

No, Im searching for those parts as well. I had all this stuff at one time... theres a reason Exs are Exs! lol

Tifany

[BadAssPerformance]

Gotcha... maybe we should move the thread to the "Parts Wanted" section?

[LaserGurl]

Hmm, might not be a bad idea.

Thanks!

[BadAssPerformance]

Done, changed the thread title too

[Jack's Dodge]

Saw a 5sp omni a week or so ago at the yard. Will check tomorrow.

[supercrackerbox]

The A525 parts might fit... never compared them.

Do you have the cables and shifter and rear trans mount for the A520 too?

Tifany, I think they'll fit, but I've never compared them either. But if they don't, I have a busted 520 in the garage and can grab the parts you need. PM me if you need them.

Also, if you're willing to attempt a little fabrication, I highly recommend against putting a cable shifter in an L-body. Or, if you can pay someone else for the fabrication, Omni-Potent has some very nice pieces for putting a rod shifter on a 520.

[OMNI-Potent]

Tifany, I think they'll fit, but I've never compared them either. But if they don't, I have a busted 520 in the garage and can grab the parts you need. PM me if you need them.

Also, if you're willing to attempt a little fabrication, I highly recommend against putting a cable shifter in an L-body. Or, if you can pay someone else for the fabrication, Omni-Potent has some very nice pieces for putting a rod shifter on a 520.

Thanks Adam!

Yes, our conversion kit will be on the website within the next few days.

Greg

[LaserGurl]

PM sent!

Oooooo! Conversion kit!! Ill be looking forward to checking that out!


Thanks Guys!

Tifany