I have a question? whats the difference between your blocks and the ones fwd sells? and is it possible to have more than 4 vac ports for the block made so its easier to clean up vac lines?
Thanx
I have a question? whats the difference between your blocks and the ones fwd sells? and is it possible to have more than 4 vac ports for the block made so its easier to clean up vac lines?
Thanx
the ones they sell are a block with threaded ports
you have to purchase the fittings seperately
then screw them all in with thread sealer on all the threads
but you get to choose what fittings you want to use
I was looking for something to clean up my engine bay a bit
these are all machined in, no threads or pressed in barbs
except on the end there is one 1/4" npt which allows you to add your own fitting , block it off, or join 2 blocks together
check out the pics on the 1st page
So right off the bat you've got (1) 1/4" barb which will except an 1/8"silicon hose too, (4) 1/8" barbs, the 3/8" barb suggested inlet and the 1/4"npt which you could add something to
so basically 6 ports on one block with only one fitting of your choice to get for $25 shipped
if we get a batch of people requesting a certain amount and sizes of barbs
I've got no problem running off a different set
lmk what you guys want
thanks
10's AGAIN '07, '08, '09
TFB Fabrications custom billet machined parts for you Turbo Mopar
Ok thanks, and you include something to mount it to firewall or back of manifold if need be?
10's AGAIN '07, '08, '09
TFB Fabrications custom billet machined parts for you Turbo Mopar
Can you post a pic of what it should look like installed ideally?
Thanks
Got mine today. Looks pretty slick. I'm going to screw my G-valve into the 1/4 NPT port, unless someone can come up with a good reason not to (length of hose to wastegate can?)
10's AGAIN '07, '08, '09
TFB Fabrications custom billet machined parts for you Turbo Mopar
I got the 2 1/2" elbow yesterday, thanks man!
That's one more piece to my Holset puzzle.
later Dick Westerhof
10's AGAIN '07, '08, '09
TFB Fabrications custom billet machined parts for you Turbo Mopar
Now thats an awesome lookin vac block. The way they should be
10's AGAIN '07, '08, '09
TFB Fabrications custom billet machined parts for you Turbo Mopar
Trade you a custom made shifter boot for the A555 for a vaccumm block?
Yeah, I've heard arguments for both ways, either manifold reference or compressor cover reference.
hey bruce what would you charge me for a Jeep TB flange bored out to 63mm rather then 60???
lmk, ill be using it too weld up to a custom intake plenum
thanks
juggz
PS thank forcefedmopar for bumpin this thread up
edit: ok didnt notice the $20 price tag....lmk if it may cost a lil extra?? need it shipped to canuckistan just north of the D lol
old thread but are the vac blocks still available?
In stock ready to ship
lmk glhs636@rcn.com
thanks
Juggy pm'd back
Last edited by "Top Fuel" Bender; 02-05-2011 at 09:27 AM.
10's AGAIN '07, '08, '09
TFB Fabrications custom billet machined parts for you Turbo Mopar
Pm sent.
You could spend about 25 just on 6 of those gold barbed fittings.. good deal.