Had these @ SDAC , will be bringing these to Carlisle
If you want it shipped probably be about $5
$25 on the vac. blocks , $20 on the flanges
I also have cast 2.5" alumn. elbows available for $20 ea.
standard 2.2/2.5/3.0/3.3/3.8 throttle flange with 60mm opening drilled and tapped for the factory studs 8mm
4.0L 60mm jeep throttle body flange again drilled and tapped 6mm
both are 1/2" thick
vac. blocks are .75" thick
1 piece billet alumn. construction
3/8" main feed port or 1/4" npt port on the opposite side
(1) 1/4" port and (4) 1/8" ports - if your using silicone hose the 1/8" will fit the 1/4" port if needed