I have a 86 glht that was converted to t2. The charge air sensor is open & needs replaced. But I do not know if the wiring is right, what terminal on the sensor is the 5 volt signal (on the 86 glht this wire is black with red) & what terminal is the signal ground ( this wire is black with light blue)?
Thanks in advance,
Todd
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS!12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
The info I have states the pin numbers are 25, but thats not what I need to know. What terminals at the sensor are the 5 volt ref & the ground? It may not mater depending on the type of sensor it is, but I don not know.
The link provides the correct pin.Originally Posted by todd900ss
Not sure, I'll look at my CAT sensor tomorrow.
Yes, it matters, you have to use a CAT sensor.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS!
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
Thanks tvanman, Let me know.
I think it would be the same on the coolant temp sensor. I will check & see what one is the 5v ref. at the conector.
Posting Permissions
Reply With Quote