Sure did,can locate and post jumper locations,I also tried programming in
different Modes Between PCB5.0 and PCB3B w/jumpers moved around
it seems to reconize changes(also w/ usb port or 12v jumpers must be moved!)not shown here though!
Everthing stays in normal mode except "speacial chip settings" see top rt for sst settings!
ShelGame=i've had your name changed(looking at buffer)ie;rod Ljo'yd--
erased chip(several times at once!)reprogram never move or touch chip!!!!
your name is then ok but errors now moved elsewhere(chip? burner?)
chip erase jumper settings(w/remove jumper after erase)
selected chip,vpp settings(manual states sst always burns @ 12v vpe even w/usb or 12v dc power!)Also lower rt corner--offset(hex)changed to 8000 then a prompt asking "program @ 0x008000 offset"=played with this= chip starts @ oooooo or 008000 offset!
thanks richard;-)