89 t2 balance shafts

[thefitisgay]

motor is in an 89 shelby daytona i was curious if they were there so i know if i have to remove them or not

any help is appreciated

[turbovanman²]

Look at the oil pan, if it has BS's, it will be deep with an angled section, if none, it will have kind of a Crop circle bottom.

Why remove them?

[thefitisgay]

i thought they like to blow up when you start making decent hp? the pan is flat accross the bottom

[turbovanman²]

i thought they like to blow up when you start making decent hp? the pan is flat accross the bottom

No, RPM kills them, not power.

Take a pic of the pan and post up.

[thefitisgay]

i hate barrowing cameras

i thougth the ones without the balance shafts had something about the size of a coffee can sticking down down in the middle forthe pickup?

[135sohc]

http://www.napaonline.com/MasterPage...motive+Engines

Thats a 2.5/balance shaft pan.

non BS has a very defined 'sump' in the center with the drain plug in the back.

[tryingbe]

89 TII 2.2L block would not have a balance shaft.

[turbovanman²]

89 TII 2.2L block would not have a balance shaft.

Unless someone put a used engine in,

[turbovanman²]

i hate barrowing cameras

i thougth the ones without the balance shafts had something about the size of a coffee can sticking down down in the middle forthe pickup?

Yes, hence the crop circle bottom I mentioned,

[thefitisgay]

i didnt know what you meant by crop circle.... so uhhh how exactly do i find out what ive got...idk which numbers to post up or where to look them up

[tryingbe]

Unless someone put a used engine in,

Unless someone put a used TI 2.5L or TIV 2.2L or TIII 2.2L.

But a 89 TII will not have balance shaft.


Common block oil pan without balance shaft.

[turbovanman²]

Unless someone put a used TI 2.5L or TIV 2.2L or TIII 2.2L.

But a 89 TII will not have balance shaft.

Exactly, you never know what people do when their engine blows,

[thefitisgay]

ok thats what i needed thanks!!

hey why isnt this in the knowledge center?