A568 unequal shaft question

[Gearjamer]

I've done a bit of a search and found that going with unequal drive shafts is prefered. I am doing an auto to A568 large spline swap in a 90 Daytona. My question is what drive shafts do I need? Will the drive shafts from my auto plug in and play with the A568 large spline?

Thanks
Bill

[tryingbe]

You already have the drive shafts you need.

[Gearjamer]

That's what I needed to know.

THANKS!

[turboshad]

I thought I read the auto drivers shaft was a tad longer than the manual shaft. I read it after I had been running the auto shaft but I can say for sure that the drivers shaft was much tighter. Though my setup is completely custom so there may be more factors at play.

[turbovanman²]

I thought I read the auto drivers shaft was a tad longer than the manual shaft. I read it after I had been running the auto shaft but I can say for sure that the drivers shaft was much tighter. Though my setup is completely custom so there may be more factors at play.

Nope, the only difference is what car it came from. L body's are the shortest, then the rest of the cars aprox 1 inch longer, followed by the van which are another inch longer.