Results 1 to 4 of 4

Thread: 86 Turbo Z Daytona CS *Ontario, Canada*

  1. #1
    Garrett booster
    Join Date
    Feb 2008
    Location
    Simcoe, ON, Canada
    Posts
    54

    86 Turbo Z Daytona CS *Ontario, Canada*



    I am selling the Turbo Z as I have no time for it and want to fund my hunting and fishing habits.

    I bought the car last winter as I wanted to save it. Payed $750 for it with a crappy set of crab wheels and tires. I then put $1250 into it in performance parts etc. I put an 88 T2 bottom end with an 87 T2 top end new mopar performance head gasket and mopar performance head bolts. It also has an 88 T2 A555 but needs a clutch (still drives and shifts through all 5 gears just fine), I think or may need the cables adjusted. (I have the A520 that was bolted to the 87 T2 engine that was in it when I bought it.) Would probably make a good parts car.

    Car has roughly 54000km on the odo, but I can not tell you if it has rolled over 100000 or 200000 km.

    THE GOOD:

    -2 piece Ported intake, has been blasted (just aluminum finish)
    -2 piece fuel rail with Forward Motion Adjustable Fuel Regulator
    -+40% Injectors (less than 500km on them)
    -52mm Throttle Body
    -Has a Fully ported exhaust manifold, done by the Turbos Unleashed porter.
    -Stainless FWD Performance turbo lines (less than 500km)
    -Red Magnecor Wires with less than 500km
    -3Bar map sensor, I socketed the SMEC and currently it has a Turbonator 8/18lbs Cal in it (but never installed the 255 so it does not have the fuel to ignite the fire)
    -Brand new innovative LC-1 Controller with XD-16 Gauge Kit (installed but not calibrated)
    -Comes with 2 Sets of Crabs 15x6.5 (have bad tires) (1 set of wheels has rash the other set has been re done in silver, no rash at all)
    -Comes with 1 set 15" Eagle alloys with rubber on them 50% tread (225/50/15)
    -Extra Gas tank with a brand new never used Walbro 255 Intank (not installed)
    -Dynamat Hood insulation, Cut not installed.
    -Has Poly Bushings Front, Pass, and tranny mounts installed and alternator bushings.
    -Direct Connection Window Louvers.
    -Nice Clarion Head unit installed with Clarion 5.5's in the doors.
    -Interior is Nice Black cloth, rear seat is ruined where the leak in the hatch is.
    -Has the T2 Short Shifter.


    THE BAD:

    Rust issues, the body its self is pretty solid except for floor pans, the drivers side is rotten up into the firewall Passengers could be as well. Has some minor rear fender rust.

    No Bobble strut Installed.

    There is a rotten spot on the seam in the hatch under the weather stripping that leaks. The T-tops leak, window scrapers are cracked, T-top moldings are cracked/broke.

    Will start and drive but does not have a licence sticker so no test drives.

    Here is the link to pictures via photobucket:
    http://s292.photobucket.com/albums/m...0CS%20Daytona/

    Here is the Big order that went through FWDP:

    Subtotal: $1,115.00
    Tax: $0.00
    Shipping: $46.00
    Handling: $11.61
    Total: $1,172.61

    Ship To: Tom Compoli

    1 Fuel pressure Test KitFWD 7-0225FWD 7-0225
    1 255 l/hr Fuel pumpFWD 7-0103FWD 7-0103
    2 Fuel Injector O-RingsFWD 7-0170FWD 7-0170
    1 30/30 Boost/vac gauge S.C.FWD 10-0103FWD 10-0103
    1 Pillar Pod DaytonaFWD 35-0246FWD 35-0246
    1 Innovate Motorsports XD-16 Gauge KitFWD 35-0942FWD 35-0942
    1 Magnecor Ignition Wires (84-90)FWD 5-0160FWD 5-0160
    1 Exhaust Manifold Studs/NutsFWD 39-0205FWD 39-0205
    1 Mopar Performance Head BoltsFWD 39-0212FWD 39-0212
    1 Timing Belt Tensioner (84-88 2.2)FWD 44-0371FWD 44-0371
    2 MP 2006 Head gasketFWD 44-0219FWD 44-0219
    1 Polybushings Alternator BushingsFWD 39-0631FWD 39-0631
    1 Downpipe Bolt KitFWD 32-0803FWD 32-0803
    1 Oil return hoseFWD 71-0669FWD 71-0669
    1 Stainless Turbo Line Kit (T-1 T-2)FWD 71-0288FWD 71-0288
    10 Hood Pad ClipFWD 36-0493FWD 36-0493
    1 52mm Throttle Body gasketFWD 44-0860FWD 44-0860
    1 O2 Bung straightFWD 32-1034FWD 32-1034
    1 48mm Throttle Body GasketFWD 44-0861FWD 44-0861
    1 Dynamat HoodlinerFWD 36-0724FWD 36-0724

    Will be Posted on OSDAC, ALLPAR.COM, TURBODODGE, and Turbo Mopar as well as Kijiji.

    Only Selling with Pick-Up * NOT SHIPPING* unless you are present.
    Is driveable and is currently in a FIT status you will be able to get a 10 day permit.

    **Looking to get $1000 obo. If no hits at all, I will be parting it out as I know I can make at least $1000 in parts.**

    Please PM me or email me tom(dot)compoli(at)sympatico.ca
    Last edited by Tonatom; 04-01-2009 at 04:31 PM.

  2. #2
    See me ride out of the sunset... Turbo Mopar Staff BadAssPerformance's Avatar
    Join Date
    Dec 2005
    Location
    Chicagoland!
    Posts
    27,699

    Re: 86 Turbo Z Daytona CS *Ontario, Canada*

    Hard to beat a running car for $1000, and this ones got several mods, someone save it from getting parted!

    JT
    SDAC Director
    SDAC-Chicago President
    JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
    87 Shelby Z - 10.50@141.66mph
    87 CSX #751 Clone - 12.88@102.88mph

    www.badassperformance.com
    Check out Turbo-Mopar Times!
    Submit your 1/4 mile times HERE!!

    Support SDAC! Join Today!
    "I'm not some pro athlete with a bajillion dollars, I'm just an every man"
    Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.

  3. #3
    ¿ Turbo Mopar Contributor oldgregg's Avatar
    Join Date
    Dec 2005
    Location
    MA
    Posts
    489

    Re: 86 Turbo Z Daytona CS *Ontario, Canada*

    If only it weren't north of the border...

  4. #4

    Re: 86 Turbo Z Daytona CS *Ontario, Canada*

    Sorry to hear you are selling... To anyone considering buying, I have had prior dealings with the seller and he is a great guy. I would have no worries dealing with him.

Similar Threads

  1. CS Daytona?
    By skitzo_inc in forum The Original "Turbo Dodge" Cars
    Replies: 14
    Last Post: 05-09-2008, 08:42 AM
  2. Wanted WTB - Daytona Turbo Z or Laser XE Turbo
    By TurboZJockey in forum Cars
    Replies: 7
    Last Post: 04-23-2008, 09:06 AM
  3. General Lots of T1 2.2/2.5 Turbo, Daytona and 600 parts
    By Dodgevanman in forum Parts For Sale
    Replies: 1
    Last Post: 02-13-2008, 02:32 PM
  4. 1988 Dodge Daytona--Parting out, in WV
    By glhkb in forum Parts For Sale
    Replies: 4
    Last Post: 07-11-2007, 01:10 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •