I was gathering up my T2 conversion parts that I cuurently have which includes a one piece intake w/ TB still attached. Late last year when I still owned a 3.0 Voyager I wanted to upgrade the TB to the larger TB, so I bought one off of Ebay. I believe it was one from a 88+ Town and Country (I will double check this tomorrow).
Anyways, as I was boxing the T2 stuff up I noticed that the Ebay TB was larger than the one still on the intake. So, I lined them up and sure enough, it IS larger.
I want to use this larger one due to the fact that it is newer looking/in better condition that the intake TB.
Will I need to hone/bore out the intake to match this bigger TB or do they line up ok?
If I do need to hone/bore the intake, what effect will this have if this is the ONLY hone/bore job done on the whole car (IE: No other porting/honing work done - just the intake to TB).
Thanks,
Paul