Anyone have some info on converting a 1 wire to a 3 wire O2?
Anyone have some info on converting a 1 wire to a 3 wire O2?
You'll need to splice into a switched & fused 12V power source and also run a ground for the sensor. There is a dark blue 14ga wire that feeds the solenoid bank that is a great spot to take the 12V from. I strongly suggest soldering all your connections.
“If the people of the nation understood our banking and monetary system, I believe there would be a revolution before tomorrow morning.” -Henry Ford
My GLH ran so much better after I did this.
Everyone says you should go with the 4 wire since it
grounds the sensor and is much more accurate.
I would do a 4 wire but the turbo already has a 3 wire in it. I would leave it 1 wire but I don't want the hassle of taking it out! I found this too http://www.turbo-mopar.com/forums/showthread.php?t=3727 .