New to the board...found you guys through the Rockauto email newsletter.
Got a '71 Scamp that I'm building into a daily driver with a little bit "more."
I'm installing a 360 bored .030 over, and am adding a FAST XFI fuel injection system with 65 lbs/hr injectors, and a Turbonetics T70 Q-trim turbo. Bottom end is built bulletproof, with a stud girdle, forged 8.5:1 Probe pistons, forged Eagle crank and H-beam rods, Edelbrock ported LA heads with 1.5 rockers.
I'd like to run a dual plane intake for better low RPM response, but none seem to be available that are drilled and ready to add fuel injection rails. In fact, the only intake I can find for a 360 that is fuel injection ready is the Eddy Super Victor EFI single plane with a power band from 3500 to 8000 rpm.
Any suggestions?