-Top half of my two piece intake manifold. ONLY the top half. Hogged out somethin' fierce by Bryan LaForest of Bully Performance. Painted black w/ the ridges sanded bare again, then cleared. Some scratches here and there. Upper runners are opened up to match the gasket and blended way up inside, the TB elbow is HUGELY opened up, and the gasket matched for a 52MM TB. a 52MM TB IS INCLUDED, just no sensors on it. I'll also include the two piece fuel rail and AFPR as well!! All of this for $250. The rail may have just started leaking the last couple times I drove the car, right by the passenger side mounting area. I thought it was an O ring but people say when the leak it's from here. I have looked over the rail and cannot find a crack on it anywhere, but I wanted to mention this just in case. So, way opened up two piece intake plenum (supported 370 whp and 395 wtq) and 52MM tb, two piece fuel rail, and an AFPR rail mounted for $250.
4-52 lb/hr "S60's" injectors. One has under 1000 miles on it from FWDP, since i had one burn out. All are in perfectly good working order, I just moved up to 72's instead. $100
555 shifter/cables. Shifter assembly was welded to the floor using plates on either side. Both cables work perfectly, although look to have gotten "bit" by the exhaust. Not bad though, most definately usable. The corssover cable has only 8K miles on it being purchased brand new from the dealer for $160!! You can have the shifter and cables for $50!!
Thanks for looking.
Aaron Miller