I'm looking for a Rear main seal retainer gasket, Front Retainer Gasket, and water pump housing seal (the one that goes between the water diverter and water pump housing).
Where can I find these other than maybe the dealer?
I'm looking for a Rear main seal retainer gasket, Front Retainer Gasket, and water pump housing seal (the one that goes between the water diverter and water pump housing).
Where can I find these other than maybe the dealer?
You can get tham all from most auto-parts stores. Should be all the same as commonblock 8 valvers.
I found both gasket sets. Will an o-ring be ok to replace the seal in the water housing?
The o-ring is just fine for the waterpump. For the front & rear seal housings I would just use anerobic sealant instead of the gaskets.
“If the people of the nation understood our banking and monetary system, I believe there would be a revolution before tomorrow morning.” -Henry Ford
Anerobic for the front and rear seal retainers, get the O-ring from Mopar then use RTV for the block to deflector on the waterpump housing.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
I just bought the timing cover and rear main seal gasket sets from Autozone. I picked up a oring there that would fit also. I think everything came out to about 18 dollars. I guess I'll just have an extra rear main seal and front crank seal,lol.
Thanks guys.