Rebuilt 3.0L 12V engine with about 1000miles. New rings, bearings, gaskets, water pump, timing belt, oil pump, ect… The heads were sent out and redone.. New valve stem seals and such. The block was hot tanked. All Mitsubishi parts were used, except for the gasket kit, which was felpro. (Note exhaust manifolds not included) Asking $400
The trans is an A543. Was told it’s the 3.77 ratio. Not sure of mileage, but it shifted great when it was in the car. Comes with center force clutch $280
Partial turbo setup that comes with the front exhaust manifold, crossover pipe and rear exhaust manifold made by Ed Kelley. Also comes with 6 t2 injectors, upper intake plenum,stock throttle body,and oil pan. The turbo is from a ford I bought rebuilt, but I do not know who rebuilt it . It has a .60 A/R on the compressor side and the .48 on the exhaust. I know that small, but I needed the Chrysler housing. No in/out shaft play, very little side/side. Comes with miscellaneous hoses, fittings, and tubes. $300 for all of it. At this time I will not separate
P-Body cruise servos , cable and vacuum box $15 each
P-Body rear tail lamps $20
1 P205/50R15 Falken tire almost new $10
3.0L SOHC 12V Engine
Cylinder heads need redone. $35
Distributor $35
Underdrive pulley and belt $55
Power steering pump $30
Neon parts
Neon new mopar a/c condense, receiver/drier and evaporator coil $260 for it all
Neon trunk lid w/spoiler green a few dents rust free $50
Neon air bags $30
Neon wiper motor $15
Neon HVAC controls $15 w/cables $10 w/out cables
Neon gas door white $10
Neon grill insert white $10
Neon ldp pump, purge valve, and evap canisters $20
Thanks for looking !!
pics: (I do have more...)