1g talon blow off valve, modded, easy TM install

[glht_omni]

i have a 1g blow off valve that i am selling, just bought a new RFL.

this had been modded per gary and gus method, will hold 30psi!!!
it also has a plate/tube flange welded on it so you can put it right where the stock plastic blow off valve goes in the rubber hose or weld it into a hard pipe if you want.

$50 shipped, all the hard work is done, just throw a hose clamp on it and go!!!:thumb

[glht_omni]

here are some pic of it installed in my r/t on the factory rubber hose that holds the stock blow off valve. its a clean looking valve as you can see. the little pipe is part of the mod as shown on the dodge garage and gus' site

[MNmopar]

pm sent on "other" forum...