thread sizes for oil distribution block

[inmyshadow]

Anybody know what the thread sizes are for the three way oil distribution block?

I grabbed one out of the junkyard for my neon. Hoping to use it as better solution to my leaky current setup for my aftermarket oil pressure gauge.

later

[turbovanman²]

If your talking the fittings on the oil block, then its 1/8 pipe thread. The block thread is 1/4-18 npt.

[turzbo]

i had a distrabution block from an 85 tona that was way to small to fit in an 89 block once.

[inmyshadow]

Thanks. I needed the info so I can get a fitting to adapt a neon OEM oil pressure sending unit.

If your talking the fittings on the oil block, then its 1/8 pipe thread. The block thread is 1/4-18 npt.