-
Creaking and cracking when steering
Hey guys...well..have a question. After finally getting the shelby running, i put everything back together...now i am getting noices when i back out of the drive way..its like a rubbing...clunking...its basicly like when you steer and you get that...crap...i don't know how to explain it...it only happens when i turn the car...well most of the time..sometimes it doesn't do it...
I had the sway bar off, along with the axles...so i put them all back on
Would bad bushing on the sway bar make this kind of noise?
Just curious if anyone know what it could be...
What kind of a noise would a rack make going bad? Thanks!
Any ideas are welcome!!
Tom
-
Re: Creaking and cracking when steering
did u roll the car with the axles out, if so then the bearings is gone, or the balljoins may be going, or the upper bearing plate, or the c.v. shaft.
-
turbo addict
Turbo Mopar Contributor
Re: Creaking and cracking when steering
We have the same problem in our Acclaim. Replaced EVERYTHING up front except outer tie-rod ends and sway bar bushings... cracking is still there. I think it's the sway bar bushings.
-
Re: Creaking and cracking when steering
im gonna guess sway bar rubbing on the control arm. If its only when youre steering could be a lot of things. When the cars sitting, bounce the front up and down and have someone watch the swaybar.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules