Just FYI....

I had to replace the inner boot on my DSS axle because they crimp the small end of the boot too close to the joint. The boot ribs rub on each other and wear through. Be sure to pull the small end of the boot down the shaft once you install it such that the ribs do not touch one another.

Also they welded the shaft to the tripod, so I couldn't get the boot off from that end. I had to remove the outer joint, which thankfully is the Citreon type that you just tap off the end of the shaft with a rubber mallot.

Another note about the inner joint: they have some kind of fiber-reinforced plastic cap that seems to be there to keep the tripod in the tulip. The problem is the boot seals to the cap and the cap seals to the tulip with a rubber gasket. On my other shaft, grease is coming out between the gasket and the tulip. I noticed on this axle that the gasket was not positioned quite right and was just barely making a seal.

I'm going to email them about the seal issue.