-
2.2 shortblock
Im in Western PA.
Looking for a GOOD condition short block. By good condition I mean NO knocking, or 200,000 miles, ect.
At least TII specs.
Will entertain all offers, but do not want to have to rebuild.
-
-
-
-
Re: 2.2 shortblock
Come on, I know someone has something.
-
-
Re: 2.2 shortblock
i have a 2.2L common block but i wont ship it.. im next to detroit
-
turbo addict
Re: 2.2 shortblock
If you find something that needs rebuilt, I can freshen it up for you. I have facilities to re-hone the block, and would re-ring it along with checking bearing clearances to see if anything needs replaced and install all new seals. I don't charge much at all on top of parts costs. I am in the Harrisburg area, not sure where vandergrift PA is. LMK if you need my help, because then you would be putting in a nice fresh shortblock in there instead of a used one thats perhaps unknown and/or you are taking somebodies word on it.
-
Re: 2.2 shortblock
If interested .Fresh turbo long block, less than 2k miles.
Rebuild 85 short block, rebuild parts from FWDP
tanked and checked, bored over,by Mets machine shop, Mansfield, OH $250
.20 over Mahle pistons
TII rods
Stock crank
New bearings seals ect
New melling pump
*new intermediate shaft from Chrysler* $178
New coil, hep, wires
89 one piece turbo valve cover
Power steering pump
water pump
most sensors on engine, knock, oil pressure
I think I put new valve stem seals in also, with 89 turbo springs.
The motor had low compresion on #3 cylinder, and I have a new mahle piston/ ring ready to go in, As i believe it has a cracked piston.
If anyone is truly interested in the complete long block, I will photograph/ document the replacement of pistion, when i do it here shortly.
Basicly the motor will be ready to drop in, ad your fuel, vacuum, thottle body etc.
I have a stock fuel rail, fpr,thottle body, and some stock injector. if needed
$500 I give you the piston, and you replace it, or
$600 I tear down document and replace piston.
Engine was pulled from my Shadow when I junked it because of frame rust,motor ran in the 12's.http://i284.photobucket.com/albums/l...2/HPIM1635.jpg
http://i284.photobucket.com/albums/l...2/HPIM1637.jpg
http://i284.photobucket.com/albums/l...2/HPIM1638.jpg
http://i284.photobucket.com/albums/l...2/HPIM1637.jpg
Greg
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules