Anybody got forged rods? Prefferably aftermarket?
Anybody got forged rods? Prefferably aftermarket?
Hopefully by Friday, I will have my barely used Eagle H-Beam Rods with RP Ross 2.5 pistons up for sale and can take pictures at that time!
Frank Katzenberger
Squirrel Performance - Home of the best turbo calc!!!
http://www.squirrelpf.com
91 Daytona Shelby - It is getting there
87 Shelby CSX #418 - Near stock is a good thing!
94 Bronco 302 XLT - Shorty Headers, 3" exhaust, cold air intake, & Soft top
"... to get the best out of it, you have to go beyond the line. Where bravery becomes insanity. Shall I turn into this hairpin bend at a 100mph? Why not!"
Visit the new Knowledge Center today!
Check out the one and only Shelby Dodge Registry!
i have several sets of stock t2 rods 50.00 a set
I should have them pulled on Saturday and give you a run down of their use. i have the head off and they look great.
Frank Katzenberger
Squirrel Performance - Home of the best turbo calc!!!
http://www.squirrelpf.com
91 Daytona Shelby - It is getting there
87 Shelby CSX #418 - Near stock is a good thing!
94 Bronco 302 XLT - Shorty Headers, 3" exhaust, cold air intake, & Soft top
"... to get the best out of it, you have to go beyond the line. Where bravery becomes insanity. Shall I turn into this hairpin bend at a 100mph? Why not!"
Visit the new Knowledge Center today!
Check out the one and only Shelby Dodge Registry!
Here is what I have... Eagle SRT-4 H-Beam rods with Ross pistons. Here are a lot of pictures. I forgot to take pictures with the bearings out, but it should be pretty obvious that they have low mileage and hadn't been spun. You can see the piston skirts are a little marked up, but I ensure you they are fine and no problems. I think my block was not properly machined, hence the noisy motors and what you see on the sides of the pistons.
It should all have less then 500 miles. $600 shipped.
Frank Katzenberger
Squirrel Performance - Home of the best turbo calc!!!
http://www.squirrelpf.com
91 Daytona Shelby - It is getting there
87 Shelby CSX #418 - Near stock is a good thing!
94 Bronco 302 XLT - Shorty Headers, 3" exhaust, cold air intake, & Soft top
"... to get the best out of it, you have to go beyond the line. Where bravery becomes insanity. Shall I turn into this hairpin bend at a 100mph? Why not!"
Visit the new Knowledge Center today!
Check out the one and only Shelby Dodge Registry!
What bore are they Frank?
I think they might be 0.35??? I will find out.
Frank Katzenberger
Squirrel Performance - Home of the best turbo calc!!!
http://www.squirrelpf.com
91 Daytona Shelby - It is getting there
87 Shelby CSX #418 - Near stock is a good thing!
94 Bronco 302 XLT - Shorty Headers, 3" exhaust, cold air intake, & Soft top
"... to get the best out of it, you have to go beyond the line. Where bravery becomes insanity. Shall I turn into this hairpin bend at a 100mph? Why not!"
Visit the new Knowledge Center today!
Check out the one and only Shelby Dodge Registry!