Body-
1987 Dodge Shadow ES Black on Red, clean 165,000 mile body, mint
Interior, 6.5 inch crabs, I have the stock ground effex kit, 90% tires,
Newer style k-member, Daytona big front discs, rear drums, new rear
Shocks, new left front wheel bearing, new sway bar bushings
Engine-
1989 2.5 cb, clean cast crank,floating rods, arp wave-loc rod bolts,
Arp main studs, arp head studs, balance shafts removed, new starter,
782 head, mp super 60 cam, stock valves and springs, new gatorback
Timing belt, T2 2pc. Intake and injectors, 52mm throttle body, polished
Valve cover, aluminum under drive pulley, new belts, water pump,
Alternator, P.S. removed, some fresh gaskets extra, also mls head
Gasket, MP stage 2 computer, stock ignition,
Turbo-
T2 garret no smoke stock swing valve, new lines, braided oil feed line
2.5 inch exhaust no cat no muffler, 2.25 inch custom intercooler
Piping all polished aluminum silicone hoses and h.d. clamps, SRT-4
Front mount custom welded end tanks, clean install with RFL blow-off
Valve, also new Monza radiator with new hoses and new electric fan
For the front mount install, new custom intake with new filter
Drivetrain-
555 getrag transmission 3:85 gear, turbos unleashed street/strip 6 puck
Clutch, 2pc. Passenger side axle, both sides are newer, poly side motor
Mount, poly filled trans mount, solid front motor mount,
Extras-
Oil pressure gauge, VDO boost gauge, HKS turbo timer (needs wired)
Strut tower bar, Dawes air/fuel gauge, Proform adjustable shift light
What needs done-
Engine is out and disassembled needs bored and a set of pistons, needs
A oil pump,
And basically assemble it everything is very fresh and clean, the block
Has been dipped and has brass freeze plugs installed, probably more to
This list but I can’t remember it all, also some receipts for the newer
Parts, the rods have a fresh line bore and arps installed
I have about 2,500 in parts and countless hours into it but need the cash bad so $1,500 takes it all if it doesn't sell im gonna part it soon