Originally Posted by
4 l-bodies
Kelly,
Here is the ARP hardware that most all of us used on the Pro-gram outer bolts.
M10X1.5x50uhl ARP # 662-1007 Bolts and washers. Blisterpak 5 to pack. You will need 2 packs, and you'll have some spares.
I have found on some blocks that you will need to double up on washers even after using bottoming tap. Careful with this as the bolts will be real close to bottoming out. One block was tapped deep enough while the other wasn't, so you need to check it.
Obviously also need to drill and tap block for the outer #4 cap, as the balance shaft cage stopped at #3.
Todd