-
1989 Dodge Omni Drag Street Project
Up for sale is my 89 Omni project car. The car currently has the stock 2.2 TBI A413 in it. 53,XXX miles on the body. I tried parting it out here
http://www.turbo-mopar.com/forums/sh...ad.php?t=15177
Interior is gutted. Metal in the doors was cut out, but still able to use the door panels as well as both A pillar trim is with car. Still has a front seats and front belts for both sides. The stock dash is intact as well as the AC/ heater box. The car is solid except for some surface rust at the bottom of the doors, a bit on the quarter and bottom of the A pillars. The only hole is in the front drivers floor board. I'll have pics up in a few hours.
Ported big valve 782 head.
Lift
.100 78
.200 132
.300 168
.400 194
.500 211
.600 216
.650 216
.700 216
.750 216
High lift Comp springs, back cut valves. It was done by HP Engines out of Mifflintown PA.
Ported 1 Piece Intake. Opened up for 52mm throttle body and port matched to the head.
52mm throttle body.
Eagle H-Beam rods from FWD Performacne.
Wiseco .020 forged 2.5 pistons
ARP Commonblock Main Studs
ARP 11mm Head Studs
Adjustable Cam Gear from FWD (round tooth)
FWD Performance High RPM Lifters.
FWD Perormance Roller Followers.
Accufab Universal FPR.
Treadstone FMIC- Overall 20x12.5x3.5, core 18.48x6x3.5 same side inlet outlet.
ALL PARTS ABOVE ARE BRAND NEW. EXCEPT FOR INTAKE TB WHICH WAS OFF A YARD CAR.
If you add up the prices from the other thread it comes to $3020.
Also included now is
1989 Omni
1990 commonblock out of a N/A Shadow. Good std. crank. It WILL clean up at .020 It wasn't done until I was going to assemble the motor
Good A413 trans out of an 87 Lebaron Turbo. Was good when the motor went, but obviously should be rebuilt with race parts for this setup.
4 Crabs. Need new rubber and should be refinished as they are peeling.
Autometer Sport comp 30 psi boost gauge, Autogauge oil pressure and water temp gauge. All new.
$2700 FOR EVERYTHING.
Thanks,
Jon
-
Re: 1989 Dodge Omni Drag Street Project
-
Re: 1989 Dodge Omni Drag Street Project
Here are some more pics. Grille and bezels are included, grille has a few small cracks. All windows work. There is no rust in the spare tire well or back floor. It's just dirt. If you have any questions, please ask.
Jon
-
Re: 1989 Dodge Omni Drag Street Project
$2400 Takes Everything!!!!!!!!
-
Authorized Vendor
Turbo Mopar Vendor
Re: 1989 Dodge Omni Drag Street Project
How much for the head?
Send a PM if you are interested.
Marion
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules