Been gathering stuff for the R/T for a while now, just need a turbo and I can get it all together.
Head went out to Lonewolf for the crack to be fixed. Had them rebuild the head, do a "performance" valve job, and tap and plug that hole on the surface. They also just finished up my stage 1 cams. I still think I am going to clean up the ports a little bit, just enough to make them round.
Motor came out running just fine, but I figured it was time for a few upgrades. So I took it over to a local shop.
Forged Venolias
File fit sealed power rings
ARP rod bolts and main studs
Mehling high volume oil pump
Cryo I-Shaft
Removed balance shafts
Brass freze plugs
Radiused all the oil holes
Shot peened rods
Fully balanced and blue printed
Obviously new bearings all throughout
I hope they did it all correctly!