Thanks to Simon and others who contributed to the original thread...
Post parts you have found that fit TIII's that are from other cars, and aftermarket suppliers.
1.) The front crank seal is CR part #11111,
2.) The cam seals are #14707-CR stands for Chicago Rawhide. You can use these numbers to cross over to any other brand, IE National etc.
3.) Dodge Viper oil cap, I took the gasket off the Viper oil cap and put it on my stocker.
4.) TI/TII/TBI commonblock can be substituted for a trashed TIII block. Grind in the water pump passage area for clearance for the water deflector. Place a core plug in the distributor hole. Crankcase breather can be added by drilling a hole in the distributor core plug and installing breather there (before installing plug!). TBI block will also need to be drilled for turbo oil return on the rear of block.
5.) Substitute thermostat gasket: Use a thermostat gasket from a '94 Dodge 5.2 V8.
6.) Head studs... Acura VTEC B18C1, 11mm. arp part number 208-4303 they are the 11mm ones for the 1.8 vtec. I had to go this route when building my engine because our vendors were out of stock, but everyone and their mothers sell honda parts.
7.) Part numbers through Goodyear for:
Radiator hose, upper 61782
Idler pulley/Serp tensioner pulley's- 49038
Radiator hose, lower 61341
Timing belt 40206
Heater hose, heater to waterpump 63073
Serpentine belt 4060785
Heater hose, heater to engine 63275
Belt numbers for no a/c or UDP.
Stock belt: 060790
Non A/C: 060660
Non A/C & UDP: 060637
I found Dayco belt # 5060670 fit with no a/c, the 60 was too short.
You insert vendors choice for the first number, IE Dayco would be a 5060790, Goodyear a 4060970 etc.