Wanted: 3" ID cast Al elbow

**BadAssPerformance** · 06-21-2007, 02:06 PM

Wanted: 3" ID cast Al elbow

Most cast Al elbows are 3" OD, I need one that is 3" ID to put between the 75mm TB and intake plenum... lemme know if you know somewhere that sells them.

**Tony Hanna** · 06-21-2007, 02:45 PM

Closest thing I could find that wasn't smaller than 3"ID, but a bit pricey @ $56.54.

**BadAssPerformance** · 06-21-2007, 06:01 PM

Ouch, a little pricey is right... was looking for a little thicker tho.

**Turbodave** · 06-21-2007, 06:20 PM

There are 3.5" aluminum (not cast) elbows on ebay:
http://cgi.ebay.com/ebaymotors/3-5-9...spagenameZWDVW

Not exactly what your looking for but they may work.

Otherwise is there something you could salvage for that part, maybe the outlet on a big intercooler, or some type of truck intake? Might be a less expensive route.

**Turbodave** · 06-21-2007, 06:30 PM

A few better ones for you:
http://cgi.ebay.com/ebaymotors/C-L-M...22279189QQrdZ1

http://cgi.ebay.com/ebaymotors/2001-...31257049QQrdZ1

http://cgi.ebay.com/ebaymotors/94-95...35795742QQrdZ1

**BadAssPerformance** · 06-21-2007, 07:33 PM

Nice finds...

**Tony Hanna** · 06-21-2007, 08:13 PM

Here's another one from Mcmaster-Carr that's a little bit heavier (sched. 40 instead of 10)

Price is a little better too. $40.38

**BadAssPerformance** · 06-21-2007, 08:42 PM

PERFECT!

Thank you!!!

**Tony Hanna** · 06-22-2007, 08:21 AM

You're welcome.

They have that elbow in sched 80 as well, but it's over $100.

**BadAssPerformance** · 06-22-2007, 08:23 AM

Damn... well 40 should be good enough

Thread: Wanted: 3" ID cast Al elbow

Thread Tools

Display

Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Re: Wanted: 3" ID cast Al elbow

Posting Permissions