-
boostaholic
3 wire to 1 wire o2
I need to run a 1 wire O2 sensor on my 87 3 wire wagon for a while...
So I guess I would wire to the black wire in the harness - should be the signal, right???
if I remember there are 2 white and 1 black.....
-
turbo addict
Re: 3 wire to 1 wire o2
Yes, the black wire on the 3-pin is the signal.
-
turbo addict
Re: 3 wire to 1 wire o2
My Sundance is running a 1 wire right now. I used a universal sensor and spliced on the plug from an old Mopar sensor so I wouldn't have to cut on the harness any.
Another little trick you can do is to hoseclamp a wire to the body of the 1 wire sensor and connect the other end to where you have your a/f gauge grounded. This helps recover a little bit of the voltage that would otherwise be lost to resistance in the ground path and will usually get you the full range on a narrowband a/f gauge once the sensor is warm.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules