What exhaust housing matches...

[Skibbe]

See attached photos.

Is there a 4-bolt exit side exhaust housing available to fit the Stage III turbine wheel on my T3/T4 hybrid?

I'm trying to match the downpipe flange. Does any one recognize it?

The standard housing I have with the port for an internal wastegate sure doesn't match. I've been scouring the internet, and the closest looks to be the KKK K-26 housing here: http://www.turboneticsinc.com/pa_turbhous.htm But, it's all euro-metric for the Porche/Audi guys, so I'm not sure if their stage III wheel is the same?

[Skibbe]

Ok, the GT series turbos are different from the old style T series turbos right?

So this 4 bolt housing for a GT series turbo won't work with my T series Stg 3 wheel?

http://www.atpturbo.com/Merchant2/me...egory_Code=BCS

[turbovanman²]

I do see what your looking for on Ebay but yeah, from what I have read, the GT series have there own set of wheels so no mix and match there.

[Skibbe]

So, is there a similar housing out there that will work? That's the 4-bolt pattern I need. I'm just not having luck finding a listing for one...

The previous owner was running an Airesearch turbo, with a .48 a/r turbine housing on it with this downpipe. I haven't been able to find a listing for that either... everything is either .63 or .82, which makes me think there is another set of turbine housings out there that I'm missing.

[turbovanman²]

So, is there a similar housing out there that will work? That's the 4-bolt pattern I need. I'm just not having luck finding a listing for one...

The previous owner was running an Airesearch turbo, with a .48 a/r turbine housing on it with this downpipe. I haven't been able to find a listing for that either... everything is either .63 or .82, which makes me think there is another set of turbine housings out there that I'm missing.

From what memory recalls yes, when searching for turbo's, I see that flange. Maybe type in T3/T4 and see what pops up. Have you called Chris at TU?

[Skibbe]

Just heard back from ATP... looks like this is the one:
http://www.atpturbo.com/Merchant2/me...egory_Code=BCS

[turbovanman²]

Looks good,

[TurboGLH]

Glad you found it. Most of the big turbo kits for srt's use the 4 bolt gt style housing with a regular t3 wheel and center section, so ATP was the place I was going to direct you.

[Skibbe]

I'm just hoping it will have the right spacing and everything. This manifold and downpipe was sized for an Aireasearch .48 a/r housing. Hopefully the ATP, presumably Garrett, housing above will put the turbo in the correct location.