H1c's were never made with a wheel that flowed nearly that much. Unless it's custom or a transplant, don't expect 65lbs. a minute. Here are the measurements of different compressor wheels made for a comparison...
(first number is inducer, then exducer in inches)
Model Compressor Turbine
Holset H1D 1.85 2.165
Holset H1D 1.969 2.165
Holset H1D/E 1.969 2.165
Holset H1D/E 2.047 2.165
Holset H1D/E 2.126 2.165
Holset H1C/E 2.126 2.244
Holset H1C/E 2.283 2.244
Holset H1C/E 2.126 2.362
Holset H1E 2.205 2.362
Holset H1E 2.283 2.362
TS04 2.300 3.304
60-1 2.324 3.000
Holset H1E 2.362 2.559
Holset HX40 2.362 2.559
T-61 2.382 3.544
62-1 2.441 3.000
Holset HX50 2.48 2.835
T-64 2.490 3.670
T-66 2.580 3.584
Holset HX50 2.638 3.031
Holset HX55 2.638 3.031
T-70 2.720 3.850
Holset HX55 2.835 3.031
T-72 2.840 4.030
T-76 3.020 4.030
So unless you are running an Hx-40 wheel in your H1c compressor housing (not possible), then you are closer to about 50lbs. a minute.