I got the round style oil pick-up. Was wondering how much material to remove from the mesh shield? Maybe someone has a pick or a link?
Thanks, Alex.
P.S. Garry has it on his site but it shows the later style square pickup. I got the round one.
I got the round style oil pick-up. Was wondering how much material to remove from the mesh shield? Maybe someone has a pick or a link?
Thanks, Alex.
P.S. Garry has it on his site but it shows the later style square pickup. I got the round one.
got from www.thedodgegarage.com
Hi Alex,
I think I removed almost all the metal covering the screen. I may of left enough for the bumps, do not remember anymore.
Do you have the deep sump pan with a bulge on the bottom, or the flat bottom pan? There are two different round pickup tubes. On the deep sump ones I pull the whole disk out of the bottom.
84 Laser XE TII A555 89 Caravan SE TIV A568
I got the one with 2 bumps on it. It's an 88 T1 block. I will get a pick of it and will post it here.
Here's the pick:
So how much should I cut off of it?
OK it's not working,
go here to see it?
http://public.fotki.com/finallall/do.../hpim0787.html
I pulled the whole disk out of the bottom, then I used a pliers to recrimp the lip so the screen was nice and tight. It worked out well, because there was some junk in the screen that I couldnt see when the disk was still installed.
84 Laser XE TII A555 89 Caravan SE TIV A568
I take the whole piece out. Put the pickup in a vice, use a hammer and screwdriver to unbend the lip, aprox 1/2 way around. Use pliers and pull it out, DON'T damage the mesh. After you pull it out, use a hammer and rebend over all the lip.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
Cool thanks guys. O, by the way Clevite makes a pick-up without the restrictive metal plate. It's Clevite Oil Pump Screen Assembly P#601-1597