I need the width of the Crank Sprocket or any dimensions that you guys can give me. I'm going to find a way to make one.
Thanks,
Joe
I need the width of the Crank Sprocket or any dimensions that you guys can give me. I'm going to find a way to make one.
Thanks,
Joe
Its the same diameter as a round tooth one, when I take mine apart, I'll measure it.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
If mine weren't at the machine shop right now i'd find out. Should get it back early this week. I'll post it if it hasn't been posted already
sure it's 1.960 " wide, that is total width. there is a spacer that is machined in it that makes it a little wider, now just the width of the belt area is 1.853"
there are also recessed area's too.you'll need alot of dimentions.. not to mention special tooling..
Turbo Joe
----------------------- 87 CSX #175 TIII powered, MegaSquirt3 Pro Ultimate, GTX3076R, Turbo Joe header, Lengel intake, Menegon ported head, the list goes on
There is a place up the street that specializes in sprockets and gears. I was going to see if they can't match it up with something else and see if I can get a machine shop to tap some holes.
I'm going to wait until I have a used one in my hands when I do talk to them.
Thank you
you can buy them from any auto parts store for 20$
my bad didn't read well enough....i'm totally wrong...
check this for making your own cogs...
http://www.aardvark.co.nz/pjet/gears.shtml
you can get a Chinese end mill for around 400
how about this???
http://www.partsamerica.com/ProductD...pe=164&PTSet=A