Crank Sprocket Question

**1qk4dr** · 02-24-2007, 02:20 PM

I need the width of the Crank Sprocket or any dimensions that you guys can give me. I'm going to find a way to make one.

Thanks,
Joe

**turbovanman²** · 02-24-2007, 02:50 PM

Its the same diameter as a round tooth one, when I take mine apart, I'll measure it.

**overlordsshadow** · 02-24-2007, 04:31 PM

If mine weren't at the machine shop right now i'd find out. Should get it back early this week. I'll post it if it hasn't been posted already

**Turbo Joe** · 02-28-2007, 10:21 PM

sure it's 1.960 " wide, that is total width. there is a spacer that is machined in it that makes it a little wider, now just the width of the belt area is 1.853"
there are also recessed area's too.you'll need alot of dimentions.. not to mention special tooling..

**1qk4dr** · 03-01-2007, 09:08 AM

Originally Posted by Turbo Joe

sure it's 1.960 " wide, that is total width. there is a spacer that is machined in it that makes it a little wider, now just the width of the belt area is 1.853"
there are also recessed area's too.you'll need alot of dimentions.. not to mention special tooling..

There is a place up the street that specializes in sprockets and gears. I was going to see if they can't match it up with something else and see if I can get a machine shop to tap some holes.

I'm going to wait until I have a used one in my hands when I do talk to them.

Thank you

**Lotashelbys** · 03-06-2007, 01:38 PM

Originally Posted by 1qk4dr

I'm going to wait until I have a used one in my hands when I do talk to them.

Well,I could let you "borrow" one if you can get it copied if im GAURANTEED to get it back

**1qk4dr** · 03-07-2007, 09:06 AM

Originally Posted by Lotashelbys

Well,I could let you "borrow" one if you can get it copied if im GAURANTEED to get it back

I actually found one locally, thanks for the offer

. I should take it in to see if they can find a duplicate. Maybe I'll do that tomorrow or next week.

**t3rse** · 03-07-2007, 12:20 PM

you can buy them from any auto parts store for 20$

**Lotashelbys** · 03-07-2007, 07:19 PM

Originally Posted by t3rse

you can buy them from any auto parts store for 20$

WHAT?? Where are you finding TIII crank timing sprockets for 20 bucks? I will take 10 at that price! Are you sure about this???

**t3rse** · 03-08-2007, 03:27 PM

my bad didn't read well enough....i'm totally wrong...

**t3rse** · 03-08-2007, 03:28 PM

check this for making your own cogs...
http://www.aardvark.co.nz/pjet/gears.shtml

you can get a Chinese end mill for around 400

**t3rse** · 03-08-2007, 04:37 PM

how about this???
http://www.partsamerica.com/ProductD...pe=164&PTSet=A

Thread: Crank Sprocket Question

Thread Tools

Display