Corroded turn signal/brake lamp sockets. Is there any way to remove the bulbs and clean the sockets, or am I better off hitting up the JY and cutting/splicing replacements in?
Corroded turn signal/brake lamp sockets. Is there any way to remove the bulbs and clean the sockets, or am I better off hitting up the JY and cutting/splicing replacements in?
The bulbs should just 1/4 turn out. If too corroded the bulb might seperate then have to try to get the base of the bulb out with needle nose pliers. Once out, cna try to clean and re-greas eteh socket. If it doesn't come out or gets damaged in the removal, or is un cleanable, then probably need to get a new (or used but better) socket.
JT
SDAC Director
SDAC-Chicago President
JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
87 Shelby Z - 10.50@141.66mph
87 CSX #751 Clone - 12.88@102.88mph
www.badassperformance.com
Check out Turbo-Mopar Times!
Submit your 1/4 mile times HERE!!
Support SDAC! Join Today!
"I'm not some pro athlete with a bajillion dollars, I'm just an every man"
Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.
I was afraid of that... These are looking pretty crusty. Is there anything I should pre-soak with?
PB Blaster is the goods for getting rusty stuff loose
JT
SDAC Director
SDAC-Chicago President
JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
87 Shelby Z - 10.50@141.66mph
87 CSX #751 Clone - 12.88@102.88mph
www.badassperformance.com
Check out Turbo-Mopar Times!
Submit your 1/4 mile times HERE!!
Support SDAC! Join Today!
"I'm not some pro athlete with a bajillion dollars, I'm just an every man"
Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.
Key I know works wonders for nuts/bolts, never tried it on electrical corrosion.
Corrosion is corrosion.
JT
SDAC Director
SDAC-Chicago President
JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
87 Shelby Z - 10.50@141.66mph
87 CSX #751 Clone - 12.88@102.88mph
www.badassperformance.com
Check out Turbo-Mopar Times!
Submit your 1/4 mile times HERE!!
Support SDAC! Join Today!
"I'm not some pro athlete with a bajillion dollars, I'm just an every man"
Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.