Trouble installing alky injection

[Dave]

I bought a Spearco alky injection kit off a member here and I'm confused...



The line on the left seems to be coming from the pump then should run down to the pressure solenoid, from there it should run to a check valve then finally to the jet.

So the line on the bottom should seem to tee into the the injection line somewhere... so what's the top line for?

How do I set it to activate at a certain boost setting?

The guy I bought it from never installed it. It was supposedly installed on Larry's (4sfed4) Omni.

[turbovanman²]

The left line is the boost reference signal as that switch mounted on the tank is a hobbs switch. I would assume you adjust it at the top of the switch, there should be a rubber plug there or if its gone, a recessed allen screw. Thats all I am good for, dont' know about the other two lines.

[Dave]

Hmmm... that helps, thanks Simon.

[Dave]

Still lost. I'm buying injectors from FWD Performance so I know what sizes I have. She reccommended a 5.1, 6.1, and 7.1 G/Hr injectors. I plan to run up to 24-26psi on pump, but now I'm only running 12psi with no intercooler yet (it's on its way).

Ideas???