Ok, from what Ive found/read/researched, in order to convert an 86/87 L-body to 87 TII electronics (i.e. 87 daytona, shadow, lebaron, etc) You have to perform 3 basic steps:
(1) Swap wire #14 on blue connector to location #9 on the red connector.
(2) Swap wire #4 on blue connector to location #4 on red connector.
(3) Install new map sensor.
(installation of map sensor involves:
(a) running a 5V+ input voltage wire from the #1 location on the red connector to the MAP sensor
(b) running a MAP sensor output wire to the #19 location on the blue connector, (c)and then running a short ground wire from the MAP to a sutible ground)
Correct?