what color interior ? any pics ?
Type: Posts; User: Fox; Keyword(s):
what color interior ? any pics ?
looking for a full center console with armrest from a burgundy/ red interior dodge spirit/ acclaim, i know they exist saw one and didnt buy it awhile ago
does it have louvers ?
i kinda am, i found a diffrent type of paper in one but im not sure where the picture is might be same thing but i dont remember the diagram just like a list with check boxes?
whats a paint defect sheet? i found the build sheets on a few of my cars under the carpet under the seats one car even had two for whatever reason, some had none
thank you very much, thats exactly what i needed
if someone has a picture of the FSM page or picture of a injector harness would be helpful, i mixed up the locations of the different injector batches, have injector 1+2 together and 3+4 but not...
looking for round tooth Adjustable cam gear any color
ah ok thanks i figured i could make these work with the disk brakes with a redrill of rotors, ill look into upgraded studs. still need to check the offset and all that
i also have some ideas on a...
interesting, cool to know there was a reason, i might continue making it, do you know if it was it the hub bearings failing or breaking studs?
i have some rear hubs from a 82 aries, ive noticed the spindle portion and mounting flange is thinner than 89 5 lug hubs, did dodge change this on the later cars to correct a issue and they are...
i just installed a set of stainless hardlines from inline tube on my csx, spec'd for a daytona but they fit well, only thing missing was the lines that go on the rear axle and for some reason they...
i ordered some from fwd so should be all good now, i just didn't know the .010 = .25 thing since i dont normally build engines
"If you mean .010 that would equal .25mm Big difference between .1 and .01 "
maybe thats it he said it was cut 10/10 but im just not familiar with the engine building lingo im sure thats...
why steel ? just curious i prefer the non steel type myself since it doesn't rust
so ive been having an engine built for awhile now, ran into a issue, was told i need .10/.10 rod and main bearings but cant find those, do they exist? seems to be a non standard size the least im...
id pay you to do mine if you be interested ( the redrill) if you go through with your project i think itd be awesome to have that low highway rpm and im willing to pay for it
i remember at one point there was a thread with pictures on this, do you happen to remember or have a link to that? im not seeing anything on my searches, im not much of a transmission guy myself and...
years later i now have the 3.05 525, now just need to find someone to do the work on it, cant even remember what All needed to be done to make it happen except the machine work to the gears cordes...
clears in the front with et33 8" wide wheel on a shadow, about flush with the fender might be out like a mm or so et35-36 might work depending on the setup with the strut, for the rear there's tons...
the main reason i wanted the atp style is to get rid of the factory gasket so i can run a more modern downpipe setup, the radius would be nice also since i dont run power steering Anyway, would...
looking for the atp swingvalve for stock t2 chrysler turbos willing to pay like 400$ LOCATED*
want Daytona louver mounting hardware- full set lower mounts and upper hinges -100$ish idk what its...
id be in for a few yards of shelby fabric if this goes anywhere
If you trick the map you'll probably get melted pistons the vnt will just put in tons of boost and lean it out
The 558 with a 4.08 fd from a voyager equiped with a 2.0l gas engine according to the seller
https://i.ebayimg.com/images/g/QosAAOSwb15cHWsP/s-l400.jpg...