Sale pending...
Type: Posts; User: cams1021; Keyword(s):
Sale pending...
Its only 470 miles..... You could do it over a weekend :o
will take $200....
one more week before this car is hauled away and sold for scrap steel....
price is negotiable.. make an offer.. car has to go!
Car is located in Yarmouth Port Mass. 02675
This is a 87 Shadow ES 2 Door with sunroof. Car had all power options. Approx 112k miles. It is an original turbo car.
It is completely rust free and...
Hey guys,
I have been building my hybrid shortblock over the course of the past 10 months. I started with a 89 common block, using a 2.2 forged crank, custom billet steel 4 bolt mains, eagle...
I am about 240 lbs. I plan on installing aluminum seats, that will drop the driver/passenger down about 2". The harness bar was installed with that in mind.
You may want to check some notes. HREW is an extremely popular choice for tubular structures in cars. Its not pipe. Pipe is plumbing equipment sized by its I.D. - it has no structural purpose. HREW...
Wyotech in Blairsville, PA... about an hour east of P-burgh
I would attach the sheet-metal piece with Lab-Metal.. then fill in the seams with some more when its done.
Thanks.
Back home to MA. Done with school for now, so I am going to find a job and start paying some bills.
You too man. Keep me updated with your projects and I'll do the same.
Thanks man. One more week and Im headed out of PA :(
I enjoyed my stay here - its a nice place :)
I work out alot.
I mean I used a manual tubing bender as opposed to a hydraulic one
Id like to, but I am running out of time here at school. I graduate in a week. If I had access for longer, I would build much more elaborate stuff
The cage started out as 50' of 1-3/4", .120 HREW tubing. Bent everything by hand. It is welded to 6x6 1/8" floor plates in the car.
The rear suspension.. boxed the entire rear axle, boxed the...
Aluminum rods are strong and light but won't last in a street engine - they stretch.
I went with eagle H-beams for a SRT-4 in my hybrid as they were the best bang:buck. Every dimension is the...
I put it on the joint between the left side elbow/T weld el pieces. Its angled just back enough to clear the head with a garrett big can wastegate on a T04E compressor housing... probably about a 40...
Finished all the port work today... total flow, all the ports combined was 877 CFM at 28" of test vac. Im happy with it :-D
The edges are beveled as you can see in the first pic. The pieces were appropriately gapped for adequate penetration. With the right size weld bead... it penetrated well. Grinding the beads smooth...
Started today.. got this far.. not bad for a few hours work.
http://tinypic.com/117r5om.jpg
http://tinypic.com/117r6s9.jpg
http://tinypic.com/117r7cw.jpg
Going to attach the weld els to...
Hey I live right by SBR in Indiana!
Count me in for April.
Ill bring cups/plates/napkins/utensils again :thumb:
70/30 white lithium grease/petroleum based motor oil
will dissolve very quickly in the oil, but also suspends the motor oil where it needs to be for as long as you want - the engine can sit for...