Applebees meeting tomorrow 7/7. As per Aj, Tim Pettijon will of Shelby Automobiles will be there for the first time in many many years. I'm not sure who that is but you OG's will probably know.
Type: Posts; User: jrod1231; Keyword(s):
Applebees meeting tomorrow 7/7. As per Aj, Tim Pettijon will of Shelby Automobiles will be there for the first time in many many years. I'm not sure who that is but you OG's will probably know.
Tomorrow night, were gonna meet up again. Hope to see everyone there.
Well be meeting up again tonight. See you guys there.
Time for another meet up. Its been a while and we should have a pretty good turnout. I'll see you guys at Applebee's this upcoming Thursday.
Heads up, we will be meeting tomorrow night at Applebee's as always. See you guys there.
John,
I'm sorry about the accident, but glad to hear you're alive. Hope you make a good recovery
-Jared
We're going to be meeting up at Applebee's again tonight. Hope to see you guys there.
I have left this issue unaddressed all year and now I've gotten to the point where I really need to sort this out. I just got an mpflash put into a spare smec and I cannot communicate through the sci...
Not sure if its economically feasible, but it would be sweet to do an all in one unit with a rotary switch for cal selection and a toggle switch for the bootstrap.
Sweet! Any idea when the 4p will ship? I've got a smec itching to receive an mpflash transplant.
For those not on facebook: The post says it was crank number 2 that broke like that. Power is probably not the underlying cause...
I'll hop on the list too if it's not too late.
1. Cordes (2x) SMEC, S
2. Cordes (1x) SBEC, S
3. knownenemy (2x) SMEC, 4P
4. ilovethecane69 (1x) SBEC, 4P
5. 85LebaronT2 (2x) SBEC, S
6....
Thursday October 1st we'll be back at Applebee's. Bring your TM and I'll see you there.
I have the boostbutton cable with the spade terminals soldered directly to the board, so I dont think I could reverse them if I tried. Nonetheless, I grabbed some cables and reversed the TX and RX...
We'll be meeting thursday Feb 6th at applebees. Mark your calendars.
I'll be there as usual with my masi
I started over and followed all instructions from this exactly. Mpscan still didnt work.
I tried the com port test in Mptune by connecting the tx and rx spade on the cable and it returned "it...
I just checked and it appears that I already have the .net framework drivers installed.
Ft prog didn't show any errors, although I'm not sure where it would alert me of that.
I had uninstalled the drivers yesterday and let the cable run through the found new hardware thing. The...
I just recently got a new laptop and I'm trying to get mpscan to work again. I'm having the same problem where Mpscan tells me that the com port cannot be setup and to turn the key off and on again....
This Thursday, October 3rd we will be having another meeting. Spread the word!
I will be there with my tc.
I'm using this cal: T-SMEC_22_ATX_A124_Masi
I made a few changes, but even when running the bone stock turbonator cal, I have the same issue.
Apologies for the late reply. It was just a dumb mistake on my part. I was using my factory smec. Once i switched over to my socketed smec, MPscan worked just fine. However, I do still have an issue...
Any ideas on what type of diode is supposed to be used and what kind of resistor? I would be willing to solder those up if someone knows.
I'm in for at least one