Found the problem. I had the wife in the air and it was the shift rod dragging my screamer pipe. Not sure what I did but I easy fix. Thanks for the answer
Type: Posts; User: jackerman; Keyword(s):
Found the problem. I had the wife in the air and it was the shift rod dragging my screamer pipe. Not sure what I did but I easy fix. Thanks for the answer
I have 555 transmission in 86 charger. Still have rod shifter with my own hiem joint rods. Question is it’s getting hard to shift reverse 1 3 and 5 but 2 4 are butter. Is there more adjustments or is...
1986-Shelby Charger-2.2 tII flic-555 3.85-24.5x8 15 M&H slicks. Joey Ackerman jackerman US
60’ 1.968 1/8 8.647 83.02 1/4 13.393 105.41
I’m running ms3pr evo
Hello fellow tmers. I have a question about our speed sensors in a 555. Should they have ohms of resistance if they are not spinning. I’m having trouble getting megasquirt to read speed. I have no...
No biggie at least you were willing to help. I ended up wiring in a key on that doesn’t lose power while cranking circuit fuse and relay. All better now thanks again cordes
It’s an 86 charger Shelby.
Ok the z1 is fed by fusible link. Is that the supply for inside fuse box #10? I was using the z1 wires as they had 12 volts to run my coil packs. I had 12v up at both green black wires till now but...
I don’t have a wire diagram available to me so I’m asking. What supplies the fuel pump fuse 12v. Any help would be awesome
Thanks guys
what knock sensor are you running. the ms3 shows 2 wires. can I run the stock 1 wire. also what is a preferred spot to install it. Im thinking of installing it in the factory location. any advice is...
That is perfect. Thank you Cordes
Hey guys I’m looking for a pin out diagram of the big connector next to brake booster. Thanks
My car has the digital dash that sometimes works. I clean all connections and used dielectric grease with no help at all. What else should I be looking for. Any ideas is appreciated
Never seen our cars with smog pump. I’d like to see that. Thanks Mike
I wonder if anybody ever set it up on the cam pulley. I don’t know if that would be adequate
Wayne Brian told me how to do it as I bought ms3 pro evo and wasn’t going to use cam sensor. Brian informed me that I wouldn’t be able to use the system to the full potential. So what I’m going to do...
Ms3 pro evo question. I have an idea but was wanting to know how everyone is running the cam sensor on an 8v. I like to see how you set the sensor up. I’m totally copying Brian’s crank sensor set up...
Gary are you still planning on going to the track. And if you are are you still bringing parts
Gary if you bring passenger side front fender for the charger I’ll take it. Also would you possibly have the ground effect. For it too
Wast the 87 t2 and intercooled
Having hard time finding the bushing for a non a/c bracket any help on who carries then will be great
Haha it was all about having fun
Well it is 100% stock with no tricks just removed spare tire lol. Made 3 pass with a goal of 17.2 and first pass 18.9 second pass was the best 17.0 and last was a 20. Not bad as I bought the car...
Took the 86 charger to the track and it was very slow almost embarrassing slow but still fun. Atco has a scale and I weighed the car and it was 2450 and all I removed was spare tire. That’s pretty...