So that's normal ?
Type: Posts; User: mrchuck; Keyword(s):
So that's normal ?
I have a 85 daytona Z T1 and the turbo get really hot, over 600 degrees fahrenheit is this normal after like 5 mins of the car just at idle ? I thought it might of been a clogged cat or muffler but I...
I have to figure out why it overheated now and why the plugs are getting fowled up, but thanks for helping me figure it out.
Well i figured i would pull the plugs & see if they were fowled and they all was. I cleaned them up and tried to start it and it ran the same. But i noticed when i was adjusting the distributor i...
I`m not sure how old the head gasket is , It has been on it since i bought it , I have never changed it figured it not leaking so why mess with it.
Yes it does have a cat (you have to have one in the great state of PA) I was told by someone else to do a compression test . I have to get the tools to do that i don`t have it.
checked the timing ...it is good & no teeth missing. I could not get the O2 sensor out of the exhaust pipe to see if was a clog. I stuck my camera down the throttle body to see if the turbo was...
The only codes i got was 12 & 55. Im moving on to checking the timing, post if i find anything else.
I haven`t checked for any codes yet. We just got done putting a new timing belt in it before to took it home.
My 85 Z runs like S#@% now...I was bringing it home from my brothers house i got about a mile away and it died on me (Overheated) and would not start back up, so i pushed it into a parking lot and...
Thank you , I got the pigtail when i got the hatch i figured i would need it. If i remember i think it`s a white wire with a red stripe & a fat black wire.
I did try to tap into afew wires but the third light was on constantly or blinked with the turn signal .
I have a 85 laser but i had to change the back hatch.I have one from a 86 that has the third brake light, well to cut this story short i took it in for a PA inspection and he told me it will not pass...
That would be great if you could send the wiring schematics from the Laser to the LeBaron, When i seen the LeBarons instrument cluster i did notice the connectors were different so i snaged them too.
I was just following what NAJ was telling me to try on the Dodge Turbo forms :
https://www.turbododge.com/threads/turn-signals-not-working.1256080/page-2#post-4523380
Fixed , Bought a new Vss and gear for the Vss put the speedo in from the 94 lebaron works great now
I dunno, I have been chatting with NAJ on Dodge Turbo fourm and this is part of what he sent me
It appears that the speed signal comes from the VSS on the OR/WT wire to the instrument cluster R/S...
I went to a u pull it got a speedo cluster out of a 94 lebaron and my speedo still don`t work. When i took it apart to inspect it i noticed on the bottom left corner of the speedo it says Denso and...
I just got a 88 lebaron digital dash and wanted to know how to swap it into a 85 laser that has a digital dash. I have the pigtails for the 88 lebaron
It`s a 2 pin vss, I tested the continuity on Circuit C7, VSS WT/OR Wire to Instrument Cluster WT/OR Wire located at the Instrument Cluster R/S 14 Pin Connector Cavity 5 and i have continuity. Then i...
I think i figured out why my speedo & odometer dont work.....the 20 & 16 teeth blue gears were broke.
I did the key dance and got 12 & 55 is there any other way to test the speedo ? I seen the gears are a common problem but with my speedo the odometer does not work either, from what i can tell...
How do you pull the codes, the key dance ?
Yes it was a bulb on the passenger side back tail light. I had another question now ... my speedo does not work i swapped it out and checked the fuses and it still does nothing, I did not know if you...
I found the problem,it was the connector on the switch it was loose i reflowed the solder and there working now, only thing now is the left blinks at nomal pace but the right one blinks like it`s on...