I am looking for a traveler for a 92-95 Spirit, Acclaim or 4 door Lebaron. It needs to be part number 4685041. I would also like any connectors you have that connect to the traveler. Thanks.
Type: Posts; User: rgl10; Keyword(s):
I am looking for a traveler for a 92-95 Spirit, Acclaim or 4 door Lebaron. It needs to be part number 4685041. I would also like any connectors you have that connect to the traveler. Thanks.
I ran mine from the freeze plug on the end of the head to the inlet side of the water pump. Fixed the number 4 spark knock problem for me. As a side note this will flow a lot of water bypassing your...
I have the same thoughts as Miles but I will add that in my experience if you want a truly cold system replace the h-valve and dryer especially if the system has been open very long to atmosphere or...
Thanks for the quick shipping and nice parts!
Put me down for 2 assembled with 7" screens. Thanks!
Pm sent.
Awesome car and I like the Mopar Garage too!
PM sent
Any chance you have something going on with your fuel? Do you use any additives? I know that some injectors seem more prone to be damaged by high ethanol content if they were not intended for E85...
They don't look like they have burnt much oil from what I can see. How much oil is the engine using? If its like a quart in 500 to 1000 miles and its getting into the combustion chamber you can...
I really like your videos on youtube! Something I tried on my last transmission and that seems to work well is an axle stabilizer. Its kinda expensive so I only used one on the drivers side of my 5...
Should be power supplied from cruise switch as one hot wire goes to switch and then three wires to go to smec from the cc switch.
I agree! I bought several things from him in the last couple of weeks. Everything was exactly as described and shipped very quickly.
Still looking
Normally drilling is not required. However it will make bleeding the air out easier. 1/16 or smaller is enough. Put the hole toward the top when thermostat is installed of course. Make sure your...
Pm sent
Pm sent
I think I will give that a try on mine. Its not overly stiff but any reduction in pedal pressure is good for me old clutch leg.
I can email you most any diagram you need. That multi-function switch controls the wiper, turn signals and head lights. Its called the SCM, steering control module. If you have access to a snap on...
You said both hoses are 10 degrees apart. Do they run 190 or so when the engine shows 200? If both are that hot then you have an air flow problem. If they both are lower like 120 or 130 at idle then...
The errors on the second two seem to be from the programmer not recognizing the chips or the chips are not TMS87C257.
Edit- Sorry Miles I was researching that very thing and you beat me to it lol.
I am just wiring up the sbec like it would be in a car. Small 12 volt motors turn the distributor and vss. I use bulbs in place of injectors and the coil. I have all the important stuff hooked up,...
I have used the willem burner with some success but i recently switched to the TL866CS and its much faster and so far no problems. I have programmed the electrically erasable chips for the 88 and 89...
I definitely want to see that!
Who would be best to use to host images?