I'm down. I'm not familiar with the inner workings of the ecus specifically,but I have decent knowledge is C ++ AND C#. I have built a stand alone gauge system for my shadow using Arduino to...
Type: Posts; User: Moparbishi; Keyword(s):
I'm down. I'm not familiar with the inner workings of the ecus specifically,but I have decent knowledge is C ++ AND C#. I have built a stand alone gauge system for my shadow using Arduino to...
The stock system will allow around 12 psi or so before it hits over boost shutdown. You'll be fine. Up it till it hits over boost then back down a bit. But high rpms will spool the little mitsu...
I can attest to the time and cost. A small chess size piece generally takes around an hour to print. Then test fit, then print again, repeat 4 or 5 more times, the. Print the final product at .1...
did you get it figured out?
I can give you what ever you need but we need more information about the car.
email sent for the new style
did you also need the one for the new style sensor?
sorry for the delay. The email is sent
OK that's what I was looking at in the diagram. 6 pin harness missing a wire. Pm me your email And I'll send you the wiring diagram for it
the bottom one is definitely for the newer manifold cars. If you need the wiring diagram pm me your email address. does yours have the 6 way connector?
I'm still very very interested as well
I have a couple sainsmarts they are kinda slow but have clear display. I use i2c and non from them
Just did a pdc on my shadow. Was really easy. Did it in about 4 hours
Are you using serial LCD or regular non serial? I found a USA source that has the serial 20x4 for 12 dollars
Well how's it going? Im interested in helping out as I an running arduino setup in my car and might have some input you could use
It is setup for t-2 but I'm not sure about ram locations
Thanks, it is still a major wip but works OK for now
first picture shows the lcd cut into the pass side dash. (i know the cutout looks bad)
The switch on top controls the page number and the momentary button below that resets the max psi reached. ...
http://carphotos.cardomain.com.s3.amazonaws.com/uploads/20151221_172349.jpg...
also noticed the dist PW is all over the place as well. Can someone take a look at theres and see what it does inder idle conditions.?
;8http://www.cardomain.com/ridepost/6316780/19132871/1989-dodge-shadow/#previous
here is a rough setup schematic
http://www.cardomain.com/ridepost/6316780/19132871/1989-dodge-shadow/#previous
There are usually one way diodes in the power Circuit as voltage protection. If one goes bad(very rare) it won't send voltage to a section of a board. Sounds like you are getting a handle on it. ...
A bunch of the caps are going to be used just as noise filters for sure. The big Circle one on the right may be the main power cap. Looks like a Ceramic non polar. I would check power on the first...
I'm using a separate 5v power supply for the LCD.
I will post some pictures tonight. The code is very long and could be cleaned up a lot, I only started learning to code in October. I made a new code using averages for the 7segs to display and...