Nice job wayne.
Evans Tuning has Megasquirt videos as well. They have a 50$/month subscription plan that I purchased for a month a few years ago to binge Hondata K-Pro tuning content among other...
Type: Posts; User: Aries_Turbo; Keyword(s):
Nice job wayne.
Evans Tuning has Megasquirt videos as well. They have a 50$/month subscription plan that I purchased for a month a few years ago to binge Hondata K-Pro tuning content among other...
\\
what bits you robbing off of that van?
can i buy the rest when you are done? lol
Brian
nice job.
when you dont have a ton of time, small setbacks are the worst lol. like 8 year delay worst for me lol.
take your time. :) youll be fine.
Brian
"get your --- in there transmission!" (small kick to get it motivated!)
again, if i wasnt 10hrs away, id be there.
i usually used a jack and a board or my buddy scotty and a rope or my cherry picker lol.
i have been known to walk through the junkyard with a...
for real lol. i had a buddy curl with both arms a a413 in place with a rope once while i threaded in the bolts lol. granted he is a bit of a freak but he got it up there lol.
Brian
i always use a cherry picker. support the engine via whatever means possible and then use a cherry picker and a piece of seatbelt or whatnot to hoist the trans in place. if you were closer id already...
of course you are going to trash the seal (who cares)
you shouldnt have a problem seeing how far in that bearing retainer side goes in.
brian
no harbor freight around to buy a cheap sawzall?
no angle grinder?
Brian
jam something up in the flexplate and use a box wrench and a hammer to loosen the bolts?
ive always been able to just whack at a box wrench with a hammer to get them loose without jamming up the...
i feel your pain. :)
https://www.holley.com/products/fuel_systems/hydramat/
Maybe this.
if it does force the puck open, its ok. just add an external spring alongside the wastegate can. take wastegate can off. drill small hole in the flat end where the flapper arm peg goes through. hook...
i dont trust the suggested line like i said before. look at it. its crazy looking. all wiggly and stuff. in your logs you have spurious lean afr's for some reason even at WOT. i think the simulator...
i think the peftbl change is a little bit too much. you arent lean up there really.
id put the line between the old and the new.
the peftbl estimator seems to be a little closer but still...
btw, i drove sean's van home from rochester to my house in warsaw (1hour) towing a daytona after the boost hose popped off the PVC coupler it was clamped to for the zillionth time.
it really...
with the turbo making no boost, the exhaust energy will be way less so it shouldnt spin the turbo as fast as when the boost is creating more exhaust energy/volume.
id put a cap over the outlet of...
He knows :-) from previous runs, the peftbl calculator gave him some goofy estimates to shoot for that weren't quite right. I took a look at the peftbl and set it by eye and gut feel of the setup and...
my machinist tapped those holes and installed threaded plugs with sealer. of course you have to make sure you dont install them too far and block oil holes that are close to the end of the gallery. ...
yeah thats the tool that i have. its wonderful.
Brian
if you have one of those valve compressor tools that hooks on the cams, you could just compress the valves and remove the rockers between the towers at the end that you are removing. then remove the...