Hi Cordes. Check your inbox. Thanks.
Type: Posts; User: krut; Keyword(s):
Hi Cordes. Check your inbox. Thanks.
For clarification:
It would be RH non T-top heated / electric
Looking for a passenger mirror with power for a 1989 Daytona.
Does anyone have one available?
thanks.
Any news on this?
Put me down for one
K
I purchased from Wayne December 28th for a MPFlash SMEC. It was extremely well packed in an oversized box with a huge amount of bubble wrap via USPS.
Due to the issues with shipping during the...
Hello.
I am putting new nameplates (both sides) on the rear of my car but I have no reference to where they are supposed to be. Does anyone have a photo or suggestions on how to properly place...
Looking for the "DODGE" and "Daytona" nameplates for an 89 Daytona.
Preferably red if in good shape.
Ideally NOS, but I know that's a stretch.
Thanks
I found a way to make things work. Disregard
Looking for the small stub vacuum harness that connects the HVAC controller to the HVAC box harness.
The one I have seems to have problems with the dark green line being clogged.
Anything out...
I have a car I just redid AC in. I’ll see if I can play a bit myself when I get home!
What tables would allow you to set idle with A/C enabled?
I'm looking through and a bit confused by which tables to use. - When AC is enabled the engine idles at about 650 - 700 rpm.
Anyone know...
Any news?
Any news on this?
Nope. You need to order the colored shells and pin it out yourself. It's not hard.
That's really cool. I was thinking about how these are used on IH's. The fuse panel clips all together like relay holders. You can pop off / pop on pieces as needed. I always wondered if someone took...
That's the HWB series. They also make smaller ones than the one you listed. So say you have like HWB16, which is a 16 pin box, etc. Some are made specifically for say 4 fuses.
I haven't played...
I have one of those RTMR's actually. It's the one I used to replace the PDC up front. It takes up about the same space as that once it's all done. It may be a bit taller. If you're interested in...
I can't stress this enough: Bussman, etc. publish engineering drawings of the parts. Make sure it fits where you want. Some of the RTMR products are DEEP once you add relays, etc. The engineering...
Found. Thanks.
https://www.waytekwire.com/products/1611/Power-Distribution/
Looking for proportioning valve PN 4485829.
89 catalog lists it as for an 89 G Body, 15 or 16" wheels.
Thank you
I remember reading that. Just wanted to make sure that if I had these if I had to trim them out of the box so that I'm fully prepared
Would the quaife axle shaft ends need to be trimmed?
Is this still going on? If so,
G-Body - L5 555 Quaife