Search:

Type: Posts; User: 86Shelby; Keyword(s):

Search: Search took 0.01 seconds.

  1. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    The last 2 posts I get this message when trying to view the attachments:
  2. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    Not really, unless it was bearings whining, which then they likely wouldn't have much life left. I've set a few transmissions with the input shaft preloaded at .005-.010(Ed Peters or 5Digits stuff...
  3. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    Check the input shaft endplay. I know that mine is a little loose since I didn't have the correct shim and it whines under power but it silent off throttle; it's done that since day one.
  4. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    What are the chances the side gear pieces could be swapped between the 2 quaiffe diffs? Then you are only working with getting the axles to work with seals, the extension housing, and the length of...
  5. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    By proper break-in you mean start it up, check for leaks, then load it on the trailer; followed by a few starts in the staging lanes with a big ol 2nd gear burnout and all topped off by a 6k sidestep...
  6. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    If you put a helicoil in the end each time you tear it down it will be easier to keep track. Heck, the case might be getting to that point anyways... :p
  7. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z - 2.4L / A568 - Update!!!

    Don't forget Lunch, Dinner and afternoon snack.
  8. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z Update!!!

    Yup they are the same. I'm using a 523 case in my R/T after machining the crank sensor hole.
  9. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z Update!!!

    I'm with Simon, on putting the case in the hot parts washer for an extended time and wait for it to drop. I've done that once with good results. 2nd time I went crazy trying different pullers,...
  10. Replies
    3,381
    Views
    441,978

    Re: BadAss SRT-Z Update!!!

    I noticed one big difference between the grey and natural colored plastic feeders from different 568s & 523s is the size of the hole in the center. The grey one is roughly 1/8-3/16" larger diameter....
Results 1 to 10 of 10